![]() ![]() This restores the backed-up data from the computer to the DJ-202. After the factory reset is complete, disconnect the USB cable to power-off the DJ-202.* Never turn off the power while the MASTER level indicator is blinking. When the factory reset finishes, all buttons and pads light up. Press the blinking button.įactory reset begins.While holding down the button in the left side (L channel) of the browser section, use a USB cable to connect the DJ-202 to your computer, and continue holding down the button until the SEQUENCER section’s button blinks.This returns all system settings, all patterns and kits (instruments) stored in the unit's memory to their factory defaults. ![]() Returning to the Factory Settings (Factory Reset) Disconnect the USB cable to power-off the DJ-202.ĭrag the "Roland" icon to the Trash icon in the Dock. Please refer to the "DJ-202 Owner's Manual" for detailed information in the. To update the TR-S, the operation in "Returning to the Factory Settings (Factory Reset)" is required after applying the update data.Įxecuting the operation in "Returning to the Factory Settings (Factory Reset)" enables you to load the most recent tone data. This is not a malfunction without turning off the power, wait for the unit to start up. * The performance pads might flash at the first startup after the update. Detach the USB cable and turn off the power.When the performance pads stay lighted, the update is complete. The performance pads flash while the update is in progress. Pressing the button in the mixer section starts the update.Copy DJ202-505_C0A_up.bin in the "dj202505_sys_112" folder into the "Roland" drive by dragging and dropping it. ![]()
0 Comments
Leave a Reply. |